Selux LED luminaires can be switched and dimmed across several interfaces (DALI, DMX, 1-10V). Use of intelligent control enables light to be dimmed individually according to customer requirements. This user oriented dimming option reduces energy consumption and makes a significant contribution to lowering CO2 emissions. Several control options are available:
Fixed setting – constant low-energy operation
In this operating mode the luminaire is not run at full power but maintained at a constant lower power setting. The power setting can be adjusted to meet site requirements.
Phase controlled night-time switching – switchable low-energy operation
In the case of phase controlled night-time switching the luminaire can be switched between two power settings. The two power settings can be configured as required.
Dynamic – low-energy operation with up to five dimming settings
The dynamic control enables low power operation of the luminaire at up to five different values. Power levels are programmed individually for each luminaire in the factory.
CLT – Constant Lumen Technology
The use of CLT ensures a constant lumen output of the luminaire over the course of its lifetime. The degradation of LED is maintained by readjustment of power. This makes for additional benefits on LED lifetime. In this way the potential for savings is fully exploited by means of an ideally configured lighting system.
With AmpDim function, the luminaire might be dimmed via its input voltage. A separate control line is not required. The correlation between input voltage and dimming level is set by programming software for the ECG. If the amplitude of the input voltage drops below a previously defined value, dimming is activated. With AmpDim you can switch between two brightness steps.